Akai APRC11M, Manual

Page: 7 / 10

Precautions & General Maintenance
Place the set on a hard and flat surface so
that the
system does not tilt.
Do not expose the set, batteries or CDs to
humidity,rain,sand or excessive heat caused
by heating equipment or direct sunlight.
Do not cover the set. Adequate ventilation
with a minimum gap of 6 inches between
the ventilation holes and surrounding
surfaces is necessary to prevent heat build-up.
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled
or lubricated.
To clean the set, use a soft dry cloth. Do not
use any cleaning agents containing alcohol,
ammonia,benzene or abrasives as these may
harm the housing.
CD player and CD handling
The lens of the CD player should never betouched!
Sudden changes in the surrounding temperature can cause condensation to form and the lens of
your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens
but leave the set in a warm environment until the moisture evaporates.
Always close the CD door to keep the CD compartment dust-free. To clean,dust the compartment
with a soft dry cloth.
To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free
cloth. Do not use cleaning agents as they may damage the disc.
Never write on a CD or attach any stickers to it.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Under no circumstances should you try to repair the set yourself,
as this will invalidate the warranty.
- Problem
Solution
TROUBLESHOOTING
X
MAINTENANCE & SAFETY
EN-6 EN-7
No sound /power
- Volume not adjusted
Adjust the VOLUME
- power cord not securely connected
Connect the AC power cord properly
-
Batteries dead/ incorrectly inserted
Insert (fresh) batteries correctly
Display does not function properly /
No reaction to operation of any of
the controls
- Electrostatic discharge
Switch off and unplug the set. Reconnect
after a few seconds
no disc indication
- No CD inserted
Insert a CD, CD-R or CD-RW
- CD badly scratched or dirty
Replace/ clean CD, see Maintenance
- Laser lens steamed up
Wait until lens has cleared
- CD-R is blank or the disc is not finalized
Use a finalized CD-R
CD/Mp3 disc playback does not work
- CD badly scratched/ dirty
Replace/ clean CD (see maintenance)
- Laser lens steamed up
Wait until lens has adjusted to room
temperature
The CD skips tracks
- CD damaged or dirty
Replace or clean CD
- Program is active
Quit Program mode(s)
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3
materials: cardboard, paper pulp and expandable polyethylene.your set consists of
materials which can be recycled if disassembled by a specializedcompacts. Please
observe the local regulations regarding the disposal of packaging, dead batteries and
old equipment.