Page 3
Page 8
6. LCD Display
7&8. TUNE, SEEK, TRACK, SKIP UP / DOWN BUTTONS
a) During RADIO mode:
Press the >>| or |<< button briefly to manual tune up/down for the desired radio
station frequency step by step.
Press and hold the >>| or |<< button for longer 0.5 seconds, to automatically tune
up/down for the radio station frequency of strong signal.
10. MODE BUTTON
Press it to select RADIO, CARD(after inserting MMC/SD card), USB(after inserting
USB stick) and AUX mode.
11. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and then
returns to its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 seconds until the real time
flashes on the display. Then you can adjust HOUR or MINUTE by pressing the
VOL- or VOL+ button .
12. PTY (PROGRAM TYPE) BUTTON
Press it briefly and repeatedly to select one of the following modes:
POP M- - NEWS
While selecting PTY TYPE, its selection is implemented by preset buttons as
described in preset key. (press one of the 6 preset buttons shortly and repeatedly
to select the PTY TYPE in the preset button) When POP M or NEWS is on, the
previous PTY program and PTY word is displayed on LCD. If there are no keys
entered for 2 seconds, previously selected PTY is searched. During 1 loop, if
desired PTY is not found, NO PTY appears on the display, and the previous normal
radio and PTY display disappears.
b) During SD/MMC & USB mode:
Press the >>| button briefly to play next track.
Press the |<< button briefly to play the previous track.
9. BAND BUTTON
During radio mode, press the BND button briefly to select the radio broadcasting
band you would like to hear. The AM/FM band is toggled cyclically through the
tuning bands: ->FM 1-> FM 2 -> FM 3 -> MW 1->MW 2 ->.
13. TA [TRAFFIC ANNOUNCEMENT] BUTTON
When pressing the button, TA mode is switched on or off.
When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA
SEEK will be displayed on LCD for a while.
When traffic announcement is transmitted:
1). If the unit is in MMC/SD, USB mode, it will switch to radio mode temporarily.
2). If volume level is below 20, volume level is raised to 20, and returns to its previous
mode and volume level when the traffic announcement is over.
If volume is adjusted during traffic announcement, only the traffic announcement
volume is valid.
* TA interruption function:
The current traffic announcement is cancelled by pressing this key. But the TA mode
will not be off.
CONNECTOR A
1.
2.
3.
4. 12V
5. Auto Antenna Output
6.
7. 12V (To Ignition Key)
8. GROUND
CONNECTOR B
1. Rear Right Speaker (+)
2. Rear Right Speaker (-)
3. Front Right Speaker (+)
4. Front Right Speaker (-)
5. Front Left Speaker (+)
6. Front Left Speaker (-)
7. Rear Left Speaker (+)
8. Rear Left Speaker (-)
ISO SOCKET SKETCH
F
U
S
E
1
0
A
ISO SOCKET
WHITE
WHITE
RED
RCA LINE OUT
REAR RIGHT SPEAKER JACK
REAR LEFT SPEAKER JACK
FRONT LEFT SPEAKER JACK
FRONT RIGHT SPEAKER JACK
RCA LINE OUT
RCA LINE OUT
RCA LINE OUT
RED
WIRING CONNECTIONS
ANTENNA JACK
