Akai AB-50, User Manual

Page: 19 / 30

TROUBLE SHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to
remedy a problem by following these hints, consult you dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the
guarantee.
PROBLEM POSSIBLE CAUSE REMEDY
No sound in general Volume not adjusted.
Mains supply is not correctly
connected.
Adjust the Volume knob.
Connect the mains supply
properly.
The unit does reset to
operation of any button
Under the influence of
electrostatic phenomenon, the
product may malfunction and
require user to disconnect.
Turn off the unit, disconnect the
mains plug, and reconnect after
a few seconds.
Radio poor reception Weak radio aerial signal.
Interference caused by the
vicinity of electrical
equipment like TVs, video
recorders, computer,
thermostats, fluorescent
lamps (TL) engines etc.
Aim the aerial for best reception:
Fully extend the telescopic
antenna.
Keep the unit away from electrical
equipment.
CD cannot read The disc is dirty
The disc is upside down.
The CD player is in Pause
mode
Clean or replace the disc
Turn it over so that the label is
face up.
Release the Pause Mode by
pressing the Play/Pause button.
No sound in USB mode Volume at minimum.
External device not connected
properly.
Adjust the volume knob.
Clear contact pins and connect
again.
TECHNICAL SPECIFICATION
Power Supply AC 230V~50Hz
DC 9V (LR14-1.5VX6 –piles non fournies)
Power consumption 13 W
Standby power consumption 0.8 W
Dimensions (H × W ×D) 105mm x 235mm x 195mm
Net Weight 1.215 kg
Radio section
Frequency Coverage FM: 87.5 – 108MHz - AM: 520- 1620 KHz
USB section Support USB flash-drive up to 8 GB
Power Output 2x1.6 W (2X0.8W RMS)
Speakers impedance 8 Ohms
18