26
AK-SecurePowerSwitch Manual,
Configuration
1 = Relay mode
Currently not activated.
2 = Button hold = 2sec
Time in seconds which has to pass until a manual switching process is accepted by
pressing the button on the front panel.
3 = Relay power on = N
Herewith you may decide if the relay is automatically switched on or not after having
switched on the device.
4 = Off if greater = 2000 watt
Herewith you may determine when the
SecurePowerSwitch
will automatically switch off.
6 = Access password =
Setting the password for the TCP/IP port. The password only has to be transmitted if it has
been configured accordingly. If a password is required, it must sent at the beginning of the
data transfer, otherwise a communication is not possible and the control port will
immediately be closed.
7 = Local Port = 1002
Herewith you determine the TCP-IP control port for the ASCII commands. It is blocked if it
is set to “0”.
8 = With SSL/TLS = N
Herewith you determine if the control port is only enabled via an encrypted connection.
N = unencrypted.
Y = encrypted via SSL/TLS
