Picture 24. Service outputs’ properties menu Т, B, J
When “Bistable“ mode is chosen for reaction, service zone reacts by
closing/opening the output depending on “Initial state” setting (NC/NO) until the
zones returns to the initial state. When the initial state is changed, green light
“12” of the appropriate service zone (Picture 1) turns on.
Output T — “Tamper”: if one of the sensors is opened or separated from the
assembling surface, its tamper button is activated and the sensor sends the
alarm signal of opening/breaking.
Output S — “Lost connection”: if one of the sensors does not send the status
signal during check time, the sensor changes the output condition S. Service
zone S will activate after the period of time equal to the parameter “Polling
period” multiplied by the parameter “Passes number” (Picture 25). By default, if
ocBridge Plus does not receive 40 heartbeats from sensor successfully, it
generates an “Lost connection” alarm.
Picture 25. Service output S properties menu
Output B — “Battery”. When the sensor the battery has run down, the sensor
sends the signal about it. When the battery has run down, zone “B” does not
function for a key fob SpaceControl, but the message about the battery running
down can be found in service events log. On the keyfob, the discharged battery
is shown by its light indication.
Output J — “Jamming“: in case it is found that the radio signal is being jammed,
the receiver changes the output J condition. Indicator corresponding to the
output J begins to light depending on the zone settings: the light is permanently
on if the zone was de ned as a bistable one; it turns on for the number of
seconds speci ed (1-254 seconds) if the zone was de ned as an impulse one.
