OG-Fiber-Series openGear Card v1.1r1 9
www.aja.com
2. If nuts and washers are pre-installed on the BNC connectors, they must be
removed before inserting the card in the frame.
3. Open the openGear frame door as follows:
A. Gently pull the side door tabs towards the center of the door, releasing the
door from the frame.
B. Using both hands, pull the door towards you. The door extender arms
prevent the door from falling.
4. Locate the Rear Card you installed as described above. The interior slot
number is dependent on the slot combinations into which you installed the
Rear Card. This allows adequate spacing to avoid damaging the card, the
cards installed in the neighboring slots, or both.
5. Hold the card by the edges and carefully align the card edges with the rails
inside the frame. The slots are numbered starting from the left-most slot
when facing the fame front.
NOTE: OG-FIBER cards are installed into the left (odd numbered) slot of the pair.
6. Fully insert the card into the frame until the card is properly seated in the
Rear Card. (
Figure 4. OG-FIBER Card Inserted Into Left Slot
7. Secure the card in the frame by the BNC connectors using the star washers
and nuts provided (
).
Figure 5. BNC Star Washer and Nut Installation
8. Insert the SFP fiber module into the socket until it clicks and locks. The lever
handle is on the left (
).