Page 16
Rudder
The rudder control can be configured as a push-pull
system or as a pull-pull cable system. See the
configuration options listed on page 3.
Push-Pull Rudder Control
The rudder is built with control horn slots for the push-
pull control system and the pull-pull control system. The
blue masking tape indicates the control horn locations.
The push-pull control horn slots are located near the
bottom of the rudder.
The pictures below shows a mockup of the rudder push-
pull system. The installation process of the servo and
control horn is the same as the ailerons and the elevator.
The pull-pull cables can be removed and the covering will
need to be patched with covering.
Pull-Pull Rudder Control
The rudder is built with control horn slots for the push-
pull control system and the pull-pull control system. The
blue masking tape indicates the control horn locations.
The pull-pull control horn slots are located higher up on
the rudder.
Cut the rudder covering to expose the control horn slots
on both sides of the rudder.
Use sand paper to roughen up the center of the control
horn so the epoxy will adhere better.
