Page 12
Fuselage
Inspect the fuselage for any interior joints that may have
loosened as a result of shipping & handling. Apply thin
CA glue around the joints of the fuselage core, firewall,
fuselage formers, and rudder servo tray to strengthen.
Locate the mounting holes for the wing. Use an iron to
seal the covering around the edges of the pocket before
trimming. There will be 2 holes for wing alignment pins,
1 hole for the wing bolt, 1 slot for the servo lead, and 1
large hole for the wing tube. Measuring from the front
edge of the firewal
l the holes can be found at 3”, 5 7/8”
,
7 ¼”, 12 ¾”. You can also locate the holes by pocking a
pin through the covering from the inside out.
Cut open the pocket just after the second small hole.
This is where the aileron servo wire will enter the
fuselage.
Locate the horizontal stabilizer pocket. Use an iron to
seal the covering around the edges of the pocket before
trimming. Use a new hobby knife blade to cut though the
covering.
