13
ENGLISH
BASIC RECORDING
This section explains how to record from the tuner, CD player,
or external equipment.
Preparation
• Set the tape to the point where recording will start.
• Use Type
I
(normal) and Type
II
(high/CrO
2
) tapes for recording.
1 Insert the tape to be recorded on into Deck 2.
Insert the tape with the side to be recorded on first facing
out from the unit.
2 Press the REV MODE button to select the reverse
mode.
To record on one side only, select
A
.
To record on both sides, select
F
or
G
.
3 Press the DOLBY NR button to turn Dolby NR on
or off.
To record with DOLBY NR, turn on
<
NR.
To record without DOLBY NR, turn on
<
NR.
4 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD,
press the CD button and load the
disc(s).
To record from a radio broadcast,
press the TUNER button
and tune in to a station.
To record from the connected source,
press the VIDEO/
PHONO/AUX button and play.
5 Press the
i
REC/REC MUTE button to start
recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording,
press the
a
button.
To pause recording,
press the
b
button. (Applicable when the
recording source is TUNER or VIDEO/PHONO/AUX.) To resume
recording, press again.
To start recording with the remote control
First press the
i
REC/REC MUTE button, and then press the
k
button within 2 seconds.
SOUND ADJUSTMENT DURING
RECORDING
The output volume and tone of the speakers or headphones
may be freely varied without affecting the level of the recording.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/PHONO/AUX.)
1 Press the
i
REC/REC MUTE button during recording or
while in recording pause mode.
REC
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the
b
button to resume recording.
To insert a blank space of less than 4 seconds,
press the
i
REC/REC MUTE button again while
REC
is flashing.
To insert blank spaces of more than 4 seconds,
after the
deck enters recording pause mode, press the
i
REC/REC
MUTE button again. Each time the button is pressed, a 4-second
blank space is added.
RECORDING
To erase a recording
Make sure the microphone is not connected to this unit.
1
Insert the tape to be erased into Deck 2 and press the TAPE/
DECK 1/2 button to display “TAPE 2”.
2
Set the tape to the point where the erasure is to be started.
3
Set the reverse mode by pressing the REV MODE button.
4
Press the
i
REC/REC MUTE button to start the erasure.
REC
