background image

USING ON AC HOUSE CURRENT

Use only an AC adaptor whose rated output is DC 5 – 6 V, 250 – 300 mA.
Connect the AC adaptor in the same way as when recharging the batteries.
During operation on AC house current, all of the battery indicator disappears.

BEFORE PLAYBACK

HOLD switch 

 

F

Release the HOLD switch before playback. 

 

a

When not using the unit, set the HOLD switch to the HOLD position. 

 

b

Accidentally pressed button will not function.
If buttons are pressed when the HOLD switch is set to the HOLD position, “HOLd”
flashes in the display.

Turning on and off 

 

F

Turning the power on

Press 

e

PLAY/PAUSE.  Power is turned on and playback starts.

Note

“Err” appears on the display when you play a disc placed upside-down or a
defective disc.

Turning the power off

If no new operations are done within 30 seconds from the end of last operation,
the power is turned off automatically. (Auto power off function)
• You can turn off the power by pressing 

s

STOP/OFF/CHARGE before it is

automatically turned off.

Standby mode 

 

F

When an operation finishes, the unit goes into standby mode until the auto power
off function automatically turns off the power.
To enter standby mode, press 

e

PLAY/PAUSE to start playback, then press

s

STOP/OFF/CHARGE.

Adjusting the sound 

 

G

Volume

Turn the VOL control to adjust the volume.

DSL

Press DSL repeatedly for more powerful sound and deeper bass.

: Deep bass is emphasized.
: Deep bass is strongly emphasized.
: Normal sound

Signal sound function

You can check the operation by beep sound when you press an operation button.
The signal sound function is activated when you purchase this unit.
To cancel the signal sound function, press 

e

PLAY/PAUSE while pressing

PLAY MODE to display “

” while in stop mode.

To resume the beep sound, repeat this procedure.

Inserting a disc 

 

H

1 Slide the OPEN switch to open the disc compartment.
2 Place a disc in the center with the label side facing up.
3 Close the disc compartment.

To remove the disc 

 

I

Pick up the disc, holding its edge, while pressing the pivot gently.

Note

• The unit may not play a CD-R/RW disc that is recorded on personal computers

or some kinds of CD-R/RW recorders because of differences in recording
platforms.

• Do not attach any seal or label to either side (the recordable side or the labeled

side) of a CD-R/RW disc. It may cause malfunction.

G

H

1

DSL

2

3

I

Summary of Contents for XP-R120









Reviews: