36
A
B
A
B
[TV / Measuring device setting] V LINEA 50 simple adjustment
Adjustment menu number
MENU1-4
Input signal
PAL CONVERGENCE
SPEC
Square
MODE
VIDEO
1. Input CONVERGENCE signal with a pattern generator.
2. Use the or - key on the remote controller to adjust each box to
draw a square. (Fig. 1-8)
Note: After adjustment, check V POS 50 (PAGE 1-2) and V SIZE 50 (PAGE 1-3).
Adjust irregularity if found.
1-5. OSD H 50 Adjustment of PAL OSD horizontal position
[TV / Measuring device setting]
Adjustment menu number
MENU1-5
Input signal
PAL CONVERGENCE
SPEC
A=B
MODE
VIDEO
1. Input CONVERGENCE signal with a pattern generator.
2. Adjust and equalize the distances indicated with A (the left end to
mark) and
B (the right end to
mark). (Fig. 1-9)
1-6. OSD V 50 Adjustment of PAL OSD vertical position
[TV / Measuring device setting]
Adjustment menu number
MENU1-5
Input signal
PAL CONVERGENCE
SPEC
A=B
MODE
VIDEO
1. Input CONVERGENCE signal with a pattern generator.
2. Adjust and equalize the distances indicated with A (the upper end to mark)
and B (the lower end to mark). (Fig. 1-10)
5-2. Adjustment of screen size and screen position (NTSC)
2-1. H POS 60 Adjustment of NTSC horizontal position
[TV / Measuring device setting]
Adjustment menu number
MENU2-1
Input signal
NTSC mono-scope
SPEC
Right and left horizontal scales are equal.
MODE
VIDEO
1. Input LION mark signal with a mono-scope.
2. Use the or - key on the remote controller to adjust and equalize
both the right and left horizontal scales. (Fig. 2-1)
Fig.1-8 PAL CONVERGENCE
Fig.1-9 PAL CONVERGENCE
Fig.1-10 PAL CONVERGENCE
Fig.2-1 NTSC MONO-SCOPE
