17
En
Adjustments
Antennas
Keep antennas away from metallic objects, electrical
equipment and cords.
FM antenna: Extend fully and position for the best reception.
If receiving condition is poor, connect optional outdoor
antenna to FM 75
Ω
terminal. Be sure to connect the shield
braid of the antenna to the
2
terminal.
MW antenna: Rotate to find best reception.
SW antenna: Extend horizontally at a high position.
For better SW reception
It is recommended that an SW outdoor antenna be extended
outside. In this case, be sure to connect the
2
SW terminal
to the ground with a ground wire (not supplied) to protect
against lightning.
DANGER
Never connect the ground wire to a gas pipe. Doing so can
cause an explosion.
To switch to monaural FM reception
Press SHIFT+TUNER MODE on the remote control. With each
press, "
MONO
" and "
STEREO
" are displayed alternately
on the display.
Tip:
When FM stereo reception is poor, switching to monaural
reduces noise.
To switch the MW tuning interval
Hold down TUNER/BAND and press POWER. With each
press, the MW tuning interval alternates between 9 kHz/step
and 10 kHz/step.
Tip:
The default is 9 kHz/step. Change it only when using the
unit in a 10 kHz/step area. Switching MW tuning interval
clears all the preset stations.
Tuning in to preset stations
On the unit
1
Press TUNER/BAND to select the band.
2
Press
d
PRESET repeatedly or turn MULTI
JOG.
With each press, the station with the succeeding preset
number is tuned in.
On the remote control
1
Press SHIFT+BAND to select the band.
2
Press the numbered buttons for the preset
number of your desired station.
- To select preset number 20, press +10, +10 and 0.
- To select preset number 15, press +10 and 5.
• Pressing
d
PRESET repeatedly can also select the
preset number.
To clear a preset station
1 Tune in to the station by preset tuning.
2 Press
s
CLEAR, then press
a
SET within 4 seconds.
Preset numbers of preset stations in the band with higher
numbers decrease by one.
