background image

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified
time.

1

Keep OSC/SLEEP pressed until “• 3”
flashes in the display.

2

Within 4 seconds, press 

r

 or 

t

 to

specify the time until the power is turned
off.

Each time it is pressed, the time changes between
10 and 90 minutes in 10-minute steps.

Example: The unit will turn off after 30 minutes.

To check the time remaining until the power is
turned off

Repeat step 1 shown above. The remaining time is
displayed for 4 seconds.

To cancel the sleep timer

Display the remaining time and press 

r

 or 

t

repeatedly until 

 (off) is displayed.

NOTE

If the unit is turned off during tape playback, 

x

 on the

deck will not be released. Press 

Z

 to release 

x

.

ENGLISH

  7

En

SOUND ADJUSTMENT

Volume or tone adjustment does not affect recording.

VOLUME (VOL)

Press VOLUME 

N

 or 

M

. The volume level is

displayed as a number from 0 to 19.
“1” in the display indicates the level 1 and “• 1”
indicates the level 11.

• The volume level is automatically set to 9 if the

power is turned off when the volume level is set to
10 or more. (except when turning the power back
on within 4 seconds)

• Pressing DISPLAY on the remote control displays

the adjusted volume level.

3-MODE EQUALIZER

Press * 3-MODE EQUALIZER repeatedly until the
desired mode is displayed.
The equalizer mode changes to ROCK, POP, JAZZ
or no equalization, cyclically.

ROCK

 - Emphasizes the high and low range of

music.

POP

 - Emphasizes voice and midrange of music.

JAZZ

 - Emphasizes the low range of music.

* or EQ on the remote control

QSOUND system

This system provides a rich, three dimensional sound
area for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.

• At higher volumes, turning QSOUND on may cause

sound distortion. In this case, make the volume
down.

The dot and number flash.

1

2

3

9

0

The volume level or a
CD track number.

While the sleep timer works
the dot keeps flashing.

(off)

ROCK

POP

JAZZ

GENERAL

QSOUND

r

t

VOLUME 

N

M

OSC / SLEEP

3-MODE 
EQUALIZER

DISPLAY

EQ

VOL 

i

k

r

t

Summary of Contents for CSD-A660











Reviews: