background image

8  

ENGLISH

1

Press CD.

The power is turned on and the CD indicator lights
up.

2

Press CD OPEN to open the disc
compartment. Place a disc with the
printed side up and close the disc
compartment.

Total number of tracks and total playing time are
displayed. It will take about 15 seconds when
loading a CD-RW disc.

3

Press *

e

 PRESET to start play.

The number of the track being played and elapsed
playing time are displayed.

* or 

c

 PLAY on the remote control

s

 

MEMORY

 – Stops play.

*

e

 

PRESET

 – Pauses play. To resume play,

press again.
* or 

a

 PAUSE on the remote control

r

,

t

 – Searches for a particular point during

playback. Keep 

r

 or 

t

 pressed and then

release it.
– Skips to the beginning of a track. Press 

r

 or

t

 repeatedly.

* REPEAT/SLEEP/FM MODE/OSC

– Repeats a single track or all tracks. Select as
follows.

[

 1 :

 A single track is played repeatedly.

Select a track with 

r

 or 

t

.

[

 :

 All tracks are played repeatedly.

* or REPEAT on the remote control

CD OPERATION

B

To start play when the power is off,

 press CD. The

power is turned on and play of the loaded disc begins
(Direct Play Function).
If you load a disc while the CD indicator flashes in step
2, play starts without pressing 

e

.

To select a track directly with the remote control,

press the numbered buttons 0-9 and +10. CD play
starts from the selected track and continues to the last
track.
Example:
To select number 25, press +10, +10 and 5.
To select number 10, press +10 and 0.

After listening,

 press TAPE/POWER/

6

STANDBY to

turn the power off.

NOTE

• Do not use irregular shape CDs (example: heart-

shaped, octagonal ones).
It may result in malfunctions.

• Do not place more than one disc in the disc

compartment.

• Do not try to open the disc compartment during play.
• Do not touch the lens. Doing so may cause

malfunctions.

• The unit may not play a CD-R/RW disc that is

recorded on personal computers or some kinds of
CD-R/RW recorders because of differences in
recording platforms.

• Do not attach any seal or label to either side (the

recordable side or the labeled side) of a CD-R/RW
disc. It may cause malfunction.

• Do not load an unrecorded CD-R/RW disc. It will take

over 30 seconds to read the disc. The disc may be
damaged if you try to open the disc compartment
while reading the disc.

CD OPEN

TAPE /

POWER /

6

STANDBY

CD

B

e

 PRESET

MEMORY 

s

r

 

DOWN

REPEAT/ SLEEP

FM MODE / OSC

UP

 

t

TUNING

Summary of Contents for CA-DW538













Reviews: