Aiwa AV-NW50, Operating Instructions Manual

Page: 7 / 22

En
ENGLISH
7
PREP
ARA
TIONS
CONNECTING THE SUPPLIED
ANTENNAS
3
Connect the FM antenna to the FM 75 Ω terminal and the AM
antenna to the AM LOOP jack.
AN
TEN
NA
AM
LO
OP
FM
75
Ω
(CO
AXIAL)
To stand the AM loop antenna on a surface
Fix the claw to the slot as shown in the illustration.
To position the antennas
Keep antennas away from metallic objects, electrical equipment
(including the unit itself) and cords.
FM antenna: Extend fully and position for the best reception. If
reception is poor, connect an optional outdoor antenna to the
FM 75
Ω terminal.
AM antenna: Rotate to find best reception.
POSITIONING THE SPEAKERS
Position the speakers to make the most of Dolby, DTS or DSP
surround effect.
Front speaker (L/R)
Centre speaker (C)
Position in the centre of the two front speakers. In addition,
position on or below the TV set, if connecting a TV set to the
unit.
Surround speakers (LS/RS)
Place the surround speakers directly to the side of or slightly
behind the listening area. Align them horizontally, about 1 metre
above ear height.
Sub woofer (SW)
Place the sub woofer in any place near the two front speakers.
Before using the unit, be sure to make speaker settings in
accordance with your speaker configuration (see page 16).
When not connecting the sub woofer
Select the "
R,VNEE
" mode when the speaker system B is
turned off.
1 Press and hold FRONT SPEAKERS A until "
EQK@QFD
" is
displayed.
2 Within 6 seconds, turn MULTI JOG so that "
R,VNM
" (initial
setting) is displayed.
3 Press ENTER.
4 Within 6 seconds, turn MULTI JOG so that "
R,VNEE
" is
displayed, then press ENTER.
USING AC OUTLETS ON THE UNIT
2
The unit is equipped with AC outlets. You can use them once the
unit is connected to an AC power socket on a wall.
Do not connect equipment beyond their capacity (120 W, 1 A
MAX. and TOTAL).
AM antenna
FM antenna