Aiwa AV-NW50, Operating Instructions Manual

Page: 19 / 22

En
ENGLISH
19
TIMER
GENERAL
SETTING THE SLEEP TIMER
SLEEP
MULTI JOG
SHIFT
JOG - , +
The unit can be automatically turned off at a specified time.
1 Hold down SHIFT and press SLEEP on the remote
control.
"
RKDDO
" is displayed.
2 Within 6 seconds, press JOG
+
or
-
repeatedly
to set the sleep timer duration.
With each press, the timer duration changes in 5-minute steps
between 5 to 240 minutes. If there is no button input for 6
seconds, the current setting is entered automatically.
The unit turns off after the selected time.
• MULTI JOG on the unit is also available.
To check the remaining time until the unit turns off
Hold down SHIFT and press SLEEP on the remote control.
The remaining time is displayed for 6 seconds.
To cancel the sleep timer
Hold down SHIFT and press SLEEP on the remote control
repeatedly so that "
RKDDOnEE
" is displayed.
TIMER GENERAL
CARE AND MAINTENANCE
Occasional care and maintenance of the unit is needed to
optimize the performance of your unit.
To clean the cabinet
Use a soft dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution. Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there an incorrect connection? (
➞
pages 4-6)
• There may be a short circuit in the speaker terminals.
➞
Disconnect the AC cord, then correct the speaker
connections.
• Was an incorrect function selected?
• Is FRONT SPEAKERS A or B set correctly? (
➞
page 9)
Sound is emitted from one speaker only.
• Is BALANCE set appropriately?
• Is the other speaker disconnected?
Sound is heard at a very low volume.
• Has MUTING been pressed?
An erroneous display or a malfunction occurs.
➞
Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
• Is the antenna connected properly? (
➞
page 7)
• Is the FM signal weak?
➞
Connect an outdoor antenna.
The reception contains noise interference or the sound is
distorted.
• Is the system picking up external noise or multipath distortion?
➞
Change the orientation of the antenna.
➞
Move the unit away from other electrical appliances.
To reset
If an unusual condition in the display window or malfunction
occurs, reset the unit as follows:
1 Press POWER
6 STANDBY/ON to turn off the power.
2 Press POWER 6 STANDBY/ON while pressing ENTER.
Everything stored in memory after purchase is cancelled.
If the power cannot be turned off in step 1 because of a
malfunction, disconnect the AC cord, and reconnect the AC cord
after several seconds. Then carry out step 2.