AIS IP10IA99 series, User Manual

Page: 11 / 77

OIC Panel 10 ” /15 ” /17 ” - User Manual (Ver.1.02)
Page 10
3.1 Electrostatic Discharge (ESD)
A sudden discharge of electrostatic electricity can damage electrostatic-sensitive devices or circuit.
Adequate packaging and grounding techniques are essential fundamentals to avoid damage. Following
precautions should be always taken:
1.
Deliver printed circuit boards in electrostatic-safe containers such as cartons, boxes or anti-static bags.
2. Keep electrostatic-sensitive parts in their containers until they reach an electrostatic-free station.
3.
Follow adequate grounding when a sensitive PCB, components, or assemblies are touched.
4. Store electrostatic-sensitive PCB’s in a protective packaging or on conductive foam.
3.2 Grounding Methods
Protect against electrostatic damage of the unit by taking the following preventative measures:
1. Cover workstations with approved anti-electrostatic material. Provide a wrist strap connected to a working bench
and properly grounded tools and equipment.
2. For extra protection by using anti-electrostatic mats, heel straps, or air ionizers.
3.
Handle electrostatic-sensitive components, PCB’s, and assemblies with care nearby the case or the edge of the
board.
4. Prevent contact with pins, leads, or circuitry.
5.
Switch off power and input signals before plugging and removing connectors or test equipment.
6. Keep the work area free from non-conductive materials such as ordinary plastic assembly aids and Styrofoam.
7. Use field service tools with conductivity, such as screwdrivers, pliers, and vacuum cleaners.
8. Always put drives and PCBs with the component-side down on the working bench.
3.3 Instructions for the Lithium Battery
Warning
Danger of explosion when wrong type of battery is replaced. Replacement only with the same type or
equivalent type recommended by the manufacturer.
Do not throw away used CMOS batteries to domestic waste. Throw away the battery according to the local
regulations dealing with the disposal of these special materials (e. g. to the collecting points for disposal of
batteries).
3.4 FCC Statement
This equipment has been tested and found to comply with the limits for a
Class A
digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection from harmful interference when the
equipment is operated in commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in residential area is likely to cause harmful
interference in which case the users will be required to correct the interference at his own expense.