MAXXFAN DOME
INSTALLATION INSTRUCTIONS,
INFORMATION AND OPERATING GUIDE
FOR MODELS 3810, 3812
READ AND SAVE THESE INSTRUCTIONS
NOTE:
Refer to Installation Instructions, Information and Operation Guides regarding the
model you have purchased.
The
MAXXFAN Dome
fan is an exhaust fan only.
The
MAXXFAN Dome
fan installs into a 6 1/4 inch diameter opening.
To determine if your roof opening is correctly sized, simply remove the interior ceiling
garnish trim ring of your existing roof vent and measure the ceiling opening or verify the
opening is large enough by sliding the
MAXXFAN Dome
sleeve into the opening.
The
MAXXFAN Dome
is designed for a minimum roof thickness of 1 inch to a maximum of
6 inches.
The
MAXXFAN Dome
fan requires a minimum 12 Volt DC, 2 amp service. Confirm that the
circuit you intend to use will accommodate the additional load. Circuit must be fused and
use appropriate gauge stranded wire for electrical connections.
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
a)
Use this unit in the manner intended by AIRXCEL, INC. If you have questions,
contact the manufacturer.
b)
Before servicing or cleaning unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on
accidentally. When the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the service panel
.
CAUTION!
FOR GENERAL VENTILATION USE ONLY. DO NOT USE TO
EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.
P/N: 11A90041Z
08-09-2019
