Doc. No.# AW70-104-01, Copy Right 2004, AirWild Hobbies, Inc.
page 24
Control Surface
Receiver Channel
Remark
Aileron, Left
Aileron, Right
Aileron
Auxiliary 1
Aileron - master channel
AUX 1 - slave channel (follows Master channel)
Enable master-slave mixing function
Make sure trim function of both channels is
controlled ONLY by Aileron Trim (master), and
that AUX 1 trim will not affect anything
Elevator, Left
Elevator, Right
Elevator
Auxiliary 2
Elevator - master channel
AUX 2 - slave channel (follows Master channel)
Enable Master-Slave mixing function
Make sure Trim function of both channels is
controlled ONLY by Elevator Trim (master) , and
that AUX 1 trim will not affect anything
Throttle
Throttle
Direct connection
Rudder
Rudder
Direct connection
Ignition Kill
Gear
Choose any free channel that is controlled by a
2-position switch, i.e. gear
Choose a position of the switch that you prefer
as the OFF state and use Channel Reverse
function of your computer radio to set ignition
On/Off state to OFF (status LED is OFF)
Then toggle switch to the opposite position and it
should set ignition kill switch to ON state (status
LED is ON)
Once programmed, check movement of ALL control surface for;
Correct direction of travel including state of ignition ON/OFF
Synchronized movement on both Master & Slave channels
Master channel’s Trim controls BOTH Master & Slave channels
Slave channel’s Trim DOES NOT affect either Master nor Slave channel
Dual rate function controls BOTH Master & Slave channels
C
C
O
O
N
N
T
T
R
R
O
O
L
L
S
S
U
U
R
R
F
F
A
A
C
C
E
E
T
T
H
H
R
R
O
O
W
W
S
S
:
:
A good starting point for control surface throws;
Aileron:
15
Up / Down
Elevator:
12
Up / Down
Rudder:
45
Left / Right
Once again please consider the above information as only a starting point of your control
adjustment. After you have a feel for the behavior of the aircraft, you can then fine-tune the
throw to match your exact flying style.