TechAssist
User Instructions
Congratulations on your purchase of the AirTurn TechAssist – your stay at home, work at home, learn at home
assistant! We hope you enjoy the many uses that this tool will provide.
Your TechAssist consists of two parts. The goSTAND and the
MANOS. The MANOS holds your tablet and goSTAND holds
the MANOS.
They connect together with a standard 5/8-27 thread
that is used in the pro audio industry for mic stands and
microphone holders.
Attaching the MANOS to the goSTAND
First set up the goSTAND. If you plan to use it at full
height, extend the feet to provide more stability. To
attach the MANOS extend the goSTAND first to waist
height.
Note: Be careful not to over tighten the thumb
screws on the goSTAND.
Loosen the two arm knobs and open the MANOS so
the two arms click to hold it flat.
Note: Do not com-
pletely remove the arm knobs from the MANOS.
Loosen the pivotknob and move the pivot perpen-
dicular to the arms. Retighten the pivot knob. Now
you can easily screw the MANOS onto the goSTAND.
Release the two arms from the clips. Squeeze open one
of the “hands” and place one edge of the tablet or
phone into the hand. Then squeeze open the other
hand and adjust the arm to engage the other side of
the tablet.
Adjust the arms inward until there is a firm fit against
your tablet and then firmly tighten the arm knobs.
Loosen the pivot knob and position to the desired tilt
and tighten firmly. Rotate the tablet or phone to the
desired portrait or landscape mode.
Note: If you plan to use a tablet in portrait mode, make
sure to place tablet off center, so more than half of the
tablet will be above the midpoint of the hands. By placing
the center of gravity higher the tablet will not droop down.
Mounting Your Tablet/Phone to the MANOS
