AirTek Twister CP Gold, User Manual, Page: 4 / 16

4
Twister CP Gold
PREPARING FOR FLIGHT
1.
UNPACK YOUR TWISTER CP GOLD.
•
Carefully remove the model and other
items from the packaging.
•
Inspect the model to check that nothing is
damaged and that all components have
been included.
•
Insert the 8 x AA batteries into the
transmitter (refer to the Twister RC radio
instructions).
http://www.jperkinsdistribution.co.uk http://www.modelengines.com.au
•
The ‘POWER’ LED will flash red.
WARNING!
•
Do not leave battery unattended when
charging
•
Do not attempt to charge a warm
battery. Allow battery to cool before
charging.
•
Disconnect battery immediately should
battery become hot to touch.
BATTERY & CHARGER
2. CONNECT CHARGER TO POWER
SUPPLY.
•
The charger is designed to automatically
charge the Li-Po flight battery in around 1
hour from a discharged state.
•
The charger is powered by the supplied
240V AC power supply or alternatively, a
12V DC power source such as a 12V gel
cell or car battery can be used.
•
Plug the connector from the AC power
adapter or the 12V DC power lead into the
socket on the right hand side of the
charger. See below:
•
If using a 12VDC power source, connect
the
red alligator clamp to the positive (+)
terminal and the black alligator clamp to
the negative (-) terminal.
•
The green LED will light and the red
‘POWER’ LED will glow solid red.
•
When the battery is fully charged, the
green LED will go out.
•
The battery can now be disconnected from
the charger and is ready for use.
3. CONNECT BATTERY TO THE
CHARGER
•
Plug the white 4 pin connector on the flight
battery into the socket on the right side of
the charger.