56
8.6
Carbon filter
Close the distributor
tube with tape
Distributor tube
Carbon filter head
Replace Carbon filling minimum once per year.
How to replace the Carbon.
•
Stop the humidification system.
•
Stop the RO system.
•
Close the water supply and disconnect water inlet and outlet hoses from the
carbon filter.
•
Make sure that you have a floor drain, or something else to collect the water
from the carbon filter.
•
Unscrew the head of the cylinder.
•
Empty the cylinder in a nylon bag to collect the carbon in the bag.
- Flush the cylinder with water remove any residue.
•
Raise the empty cylinder again.
•
Close the distributor tube with light sticky tape or a plug.
•
Fill the cylinder with new carbon. The right volume, see section 4. datasheet.
- Do not overfill.
•
Remove the tape/plug from the distributor tube and screw the head back on.
Startup.
•
Now the cartridge must flush against the flow direction.
- Connect supply water hose to filter OUT.
- Connect drain to filter IN.
•
Slowly open supply water until you see water to drain and and let it flush for
15 minutes.
Be carefull not to flush the carbon out.
•
Close the supply water again.
•
Reconnect water inlet and outlet back to standard connection, and let it flush
again for 15 minutes in right flow direction, before setting the filter back to
operation.
201218
