D
EXTERIOR
D - 15
6.
Insert the pole ends into the grommet holes in the webbing (Figure 6A & 6B). You
need to flex the poles in order to insert the other end of the pole into the grommets on
the opposite side of the tent.
7. Slide each of the long black-tip poles ball-end first into each of the navy sleeves that
run the length of the tent (Figure 7). Feed each pole into the sleeve until it fully seats
against the closed end at the top of the tent.
8. Insert the pole ends into the grommet holes in the webbing.
9. Locate the grooves in the BaseCamp trailers roof and bumper (Figure 9).
10. Locate the webbing that is sewn into the outer edge of the opening on the tent
(Figure 10). This webbing will sit in the grooves in the top and bottom of the trailer.
11. Place the webbing (and tent sleeve) in the grooves on the top and bottom of the
trailer. Make sure that the webbing lies flat within the grooves.
Figure 6A
Figure 6A
Figure 7
Figure 10
Figure 9