Airspan AS4000, Installation Manual

Page: 135 / 193

Setup and Test
131
Set Traffic/Management Ports
The traffic port connects to the Ethernet connecting to the internet service provider and the
management port connects to the Netspan server.
Enter the following parameters from the front panel of the AS4020. The values are
determined by the server that the network is connected to.
IP address = in the form xxx.xxx.xxx.xxx i.e 192.254.130.030
Subnet mask = in the form xxx.xxx.xxx.xxx i.e 255.255.000.000
Gateway address = may be used if management is on another network else set to
000.000.000.000
Broadcast Address = used for broadcasts and would usually be the network address
and mask so for the IP network above would be 195.254.255.255 but this information
should be provided by the network administrator.
Ethernet Rate. Set to the rate dictated by the network, if in doubt set to Auto
Duplex Mode