Airrex AH-300, User Manual

Page: 6 / 20

6
STRUCTURE & DESCRIPTION
STRUCTURE & DESCRIPTION FOR MODEL
Exhaust Duct
Heating
Tube
Safety Grille
Back Reflection
Oil tank
Side
Reflection
Bottom
Reflection
Power code
(a.c. 220/230V only)
Control Panel
CONTROLLER
TILT
LOCK
LOCK
Cur Temp Set Temp / Time
FUEL
EMPTY
MISFIRE
OVERHEAT
1. LED DISPLAY
It displays the status of temperature, time,
operation, and error, etc.
2. TEMPERATURE CONTROL MODE
It is lighten at the temperature control mode.
3. TIME CONTROL MODE
It is lighten at the time control mode.
4. IR RECEIVER FOR REMOTE CONTROLLER
5. ON / OFF
Run and stop button
6. TEMP/TIME SELECTION BUTTON
To select temperature or time control mode.
7. UP/DOWN
To set or change the temperature or time.
8. LOCK
If you push this lock button for 3sec,
the controller is locked. And if you push
again for 3sec. this fuction is released.
9. OFF TIMER
To select whether off timer mode is
operated or not.
10. OFF TIMER LED
To show whether off timer mode is
operating.
11. MISFIRE
It shows the misfire on the burner.
12. OPERATION LAMP
It is lighten on operation.
13. FUEL GAUGE DISPLAY
It displays fuel remain in 3 steps.
14. OVERHEATING
It shows overheating status if the
temperature goes up to 105
℃
.
15 TILT SENSOR
It is turned on in case of inclination
over 30deg. or an excessive motion
is detected.
16. LACK OF FUEL
It shows the remaining fuel amount.
17. LOCK LED
When the machine is in the lock
mode, the LED of this LOCK is
lighten.
overheating
sensor
(Automatic
Recovery)
Electronic
fuel pump
Fuel inlet
Fuel tank
Air suction
hole
Igniter
Tilt sensor
Fuel gauge
burner
Flame
sensor(CdS)
Fuel filter
Control
panel