Parts & Features
1. We recommend keeping the packaging for off-season storage and for any transportation needs.
2. Find a level and unobstructed location to place the unpackaged heater.
3. Do not plug in or run any appliances on the same circuit that the heater is on.
4. Plug the power cord directly into an unused, grounded outlet.
Used to turn the heater on and off. This will only work if the master power switch
(shown above) is on.
Used to increase the desired temperature.
Used to decrease the desired temperature.
Used to switch between LOW and HIGH modes.
a. LOW MODE:
In low mode, the heater runs on a lower wattage in order to
use less electricity.Running the heater in low mode can sometimes be more
beneficial in smaller rooms where less heat is necessary.
b. HIGH MODE:
In high mode, the heater consumes more wattage but also
produces more heat. High mode is recommended for larger rooms that are
harder to keep warm.
IMPORTANT: To turn the heater off, press the “POWER” button; the fan will continue to run until
all of the heat has been expelled. This could take up to 3 minutes in some cases.
DO NOT UNPLUG WHILE RUNNING
.
Washable Lifetime Filter System
ComfortDELUXE heaters come with a washable
lifetime filter that is easy to clean.
IMPORTANT INFORMATION: If you have allergies
and/or are sensitive to dust, you will want to use
this filter. When choosing to use the filter, it must
be cleaned as often as necessary; a clogged filter
will prevent the heater from working to its fullest
capacity. If the heater is used in an extremely dirty
or dusty area, the filter must be cleaned more
frequently to keep it from clogging.
To clean the filter:
1. Release the filter. (See pictures)
2. Run warm tap-water over the filter in the
opposite direction of air flow, until the water
runs clear. The filter might excrete some fil-
tered residue so be cautious not to drip on any
stainable surfaces such as carpeting. You can
also soak the filter in water mixed with a small
amount of mild dish soap. Don’t forget to dry
the filter after it has been rinsed.
3. Shake the filter over a sink until excess water is
removed and allow it to dry completely before
reinstalling. DO NOT force the filter to dry
using any alternative methods.
4. Reinstall the filter to the rear of the unit
(Diagrams on next page.)
COMFORT
D E L U X E
With Copper PTC
AirNmore
