Inspection Warnings
(Continued)
NEVER INSTALL OR OPERATE A DAMAGED UNIT.
WARNING – MAXIMUM AIR TEMPERATURE FOR AIR PASSING THROUGH
UNIT IS 110 DEGREE F (43 DEGREES C). NEVER ALLOW AIR TO PASS
THORUGH THE UNIT IN EXCESS OF THIS VALUE. PERSONAL INJURY OR
PROPERATY DAMAGE MAY RESULT.
DANGER – NEVER OPERATE UNIT WITHOUT INLET AND OUTLET GUARDS
IN PLACE.
DANGER – NEVER INSERT OBJECTS NOR ALLOW OBJECTS TO ENTER
THE FAN. SUCH OBJECTS MAY BE EJECTED CAUSING PERSONAL
INJURY.
DANGER – RISK OF INGESTION OF HAIR, CLOTHING, OR JEWELERY THAT
MAY GET PULLED INTO FAN. ALWAYS MAKE SURE THAT SUCH ITEMS ARE
SECURED AND KEPT AWAY FROM INLET OF FAN.
DANGER – EXERCISE CAUTION WHEN HANDLING PACKAGING MATERIAL.
NEVER ALLOW SUCH MATERIALS TO BE ACCESSED BY CHILDREN WHO
RISK SUFFICATION.
WARNING – MOTOR CONTAINS INTERNAL ELECTRONICS WHICH PRE-
VENT THE FAN FROM OVERLOADING AND / OR OVERHEATING. SHOULD
THE UNIT STOP DURING OPERATION ALLOW THE UNIT TO COOL
(MAY TAKE AS LONG AS 30 MINUTES) BEFORE ATTEMPTING TO RETURN
THE UNIT TO SERVICE)
Operation
The ECo Mancooler is simple to operate, simply plug into appropriate electrical receptacle
(outlet) and switch on. The on / off switch is located near the top of the unit (just off to
one side). It is a rotary switch that both turns the unit on / off and adjusts the speed.
The unit’s speed can be adjusted from 100% speed down to approximately 10% of speed.
Adjust the speed according to personal comfort. To turn off - Rotate switch counter
clockwise until it clicks off.
Note: On start-up the EC motor needs to determine the position of the rotor in order
to operate properly. In doing so, it may actually run backwards for a very short period of
time. Unit may cog (jump from position to position) at very low speed. This is normal
operation.
Particularly when the unit is first put into use, observe the unit for any abnormal vibration
(greater than .25 inches / second). If unit seems to be vibrating, make sure that all four wheels
are in contact with floor. If necessary, reposition unit so that all four wheels are supported.
If unit seems to be vibrating abnormally immediately shut unit off and consult factory.
Page 2
Version 1.0
ECo IOM Manual
