5
INSTRUCTION FOR THE INSTALLER
The operations indicated below must be followed by qualified personnel
exclusively, in conformity with the regulations in force.
The manufacturing firm refuses all responsibility for damages to people,
animal or things, resulting fron the failure to comply with such provisions.
INSTALLATION
•
The appliance is designed to be embedded into heat-resistant pieces of
forniture.
•
Make a hole in the top of the piece of forniture with the dimension
indicated in fig.4 at a distance of at east 50 mm from the appliance
border to the adjacent walls.
•
Adhesive washer “S” along the border of the top bottom (fig.5).
•
Block it with the fastening hooks “C” (fig.6)
ELECTRICAL CONNECTIONS ( fig.7)
Before carryng out electrical connection be sure that the characteristics of
the electrical system meet the specifications of the located at the bottom of
the work-top and the electrical system is provided with effective ground in
compliance with the regulations and provision of the law in force.
The ground is binding according to the law.
If the appliance is not provided with cable and/or relative plug, apply a
standardized plug to the power supply cable.
If you wish a direct connection to the line, it is necessary to interpose a
means for disconnection having a contact separation in all poles that provide
full disconnection under overvoltage category III conditions.
The ground conductor is marked by the yellow-green colors.
If the power cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
