AirLink Communications Raven CDMA/1x, User Manual, Page: 73 / 115

Raven CDMA User Guide for Verizon, version 2.23
67
S0= n n =0 | 1 | 2 | 3 This register determines how the Raven responds to an
incoming TCP connection request. The Raven remains
in AT Command mode until a connection request is
received. DTR must be asserted (
S211=1 or &D0 ) and
the Raven must be set for a successful TCP connection.
The modem will send a "RING" string to the host. A
"CONNECT" sent to the host indicates acknowledge-
ment of the connection request and the TCP session is
established.
0 : Off (Default)
1 : On
2 : Use Telnet server mode on TCP connections.
3 : With a Telnet connection, overrides the client's
default echo, allowing the server on the host port to per-
form the echo. CRLF sequences from the telnet client
will also be edited to simply pass CRs to the server on
the host port.
S7= n n = seconds Specifies the number of seconds to wait for a TCP con-
nection to be established when dialing out.
S23=[ speed ],[ databits ]
[ parity ][ stop bits ]
speed =
300 | 1200 |
2400 | 4800 |
9600 | 19200 |
38400 | 57600 |
115200 | 230400
databits = 7 or 8
parity =
O | E | N | M
stopbits =
1 | 1.5 | 2
Serial line parameters. The settings take affect after
reset.
Ex. ATS23=19200,8N1 (sets modem to 19200, etc.)
Note: Databits MUST be 8 data bits for PPP mode.
Can also be set using &L =[ speed ],[ databits ] [ par-
ity ][ stop bits ]
O=Odd E=Even N=None M=Mark
S50= n n = tenths of
seconds
Data forwarding idle time-out. If set to 0, a forwarding
time-out of 10ms is used.
(Used in UDP or TCP PAD mode)
TABLE 6.
Local Network and Host Modes
Command Parameters Details