WARNINGS -
READ FIRST BEFORE USING PRODUCT
Reversible
Spray Tip
Tip Guard
Trigger
Guard
MAJOR COMPONENTS OF SPRAY
GUN AND REVERSIBLE SPRAY TIP
SPRAY GUN
Attach spray gun to airless unit and tighten fittings securely.
Set the gun safety latch. (Also may be called gun safety lock,
or trigger lock)
*
The gun safety latch should always be set when the gun is
not being triggered.
Read all warnings and safety precautions supplied with the
spray gun and in product manual.
SPRAY TIP ASSEMBLY
PROLIGHT GUN OPERATION
1.
Be sure the pressure relief procedure is followed
before assembling tip and housing to the gun.
2.
Insert REV-TIP™ cylinder into the REV-GUARD™
(guard housing assembly).
3.
Guide the metal seat into REV-GUARD™ (guard
housing assembly) through the retaining nut and turn
until it seats against the cylinder.
4.
Insert the O-Ring gasket onto the metal seat so that it
fits into the grooves.
5.
Finger tighten REV-GUARD™ retaining nut onto the gun.
6.
Turn guard in the desired position.
7.
Completely tighten the retaining nut.
O-Ring Gasket
Metal Seat
REV-TIP™ Cylinder
Retaining Nut
Spray Position Shown
Reverse to
Unplug
REV-GUARD™
Guard Housing Assembly
TO REMOVE CLOGS FROM SPRAY TIP
1.
Lock gun safety latch.
2.
Turn REV-TIP™ handle 180 degrees.
3.
Disengage trigger lock and trigger gun into
the pail.
4.
If the REV-TIP™ handle appears locked
(resists turning), loosen the retaining nut. The
handle will now turn easily.
5.
Engage gun safety latch and return handle to
the spray position.
Retaining Nut
CLEANING SPRAY GUN
CLEANING FILTER IN GUN HANDLE
Immediately after the work is finished, flush the gun out with
a solvent. Brush pins with solvent and oil them lightly so
they will not collect dried paint.
To clean the filter, use a brush dipped in an appropri-
ate solvent. Change or clean filters at least once a day.
Some types of latex may require a filter change after
four hours of operation.
Handle
(filter inside)
Gun Safety
Latch or lock
CLOGGED FLAT TIP
Should the spray tip become clogged, relieve pressure from
hose by following the "Pressure Relief Procedure." Secure
gun with the safety latch, take off guard, take out the tip,
soak in appropriate solvent & clean with a brush. (Do not
use a needle or sharp pointed instrument to clean the tip.
The tungsten carbide is brittle and can chip.)
2
™
™
Press up here and pull
gently to remove guard
