Pinion Assembly/Clutch Armature/Clamp
3A4108F
27
Clamp Removal
1.
Remove engine.
2.
Drain gasoline from tank according to
Briggs & Stratton manual.
3.
Tip engine on side so gas tank is down
and air cleaner is up.
4.
Loosen two screws (24) on clamp (22).
5.
Push screwdriver into slot in clamp (22)
and remove clamp.
Clamp Installation
1.
Install engine shaft key (18).
2.
Tap clamp (22) onto engine shaft (A).
Maintain dimension shown note 2.
Chamfer must face engine.
3.
Check dimension: Place rigid, straight
steel bar (B) across face of clutch
housing (19). Use accurate measuring
device to measure distance between bar
and face of clamp. Adjust clamp as
necessary. Torque two screws (24) to
125 ±10 in-lb (14 ±1.1 N•m).
ti29235a
4
3
2
1
ti29237a
Face of clutch housing
1.550 ± .010 in.
(39.37 ± .25 mm)
Torque to 125 ± 10 in-lb
(14 ±1.1 N•m)
Chamfer this side
1
2
3
4
B
A
23,24
19
5
22
18
Summary of Contents for GS950
Page 34: ...Notes 34 3A4108F Notes...
