4
Guide for Airfree
®
installation in mould contaminated rooms
1 - Install your Airfree
®
unit in accordance with the user manual
2 - Allow your unit to run for at least one week to achieve significant airborne mould spore reduction.
3 - Clean mould infected items and surfaces, since they are a continuous source of new spores.
It is important to stress that Airfree
®
will not destroy or remove mould from an infected item or surface.
Those surfaces must be cleaned manually.
Airfree
®
will destroy airbone moulds, spores and prevents them from contaminating other areas, inhibiting
the growth of existing and new colonies.
Airfree
®
and Mould
Installing and Connecting
Plug power cord into the nearest outlet. Make sure the surface is dry (never place Airfree
®
on
wet floor or immerge it in water). Make sure side led light is on.
Adjust the night light intensity
with the touch sensor. After 10 minutes the top lid should be warm.
Place Airfree
®
on a flat surface not exceeding 75 cm from the floor, not under furniture, shelves,
or behind curtains as it will reduce airflow and Airfree
®
efficiency in reducing microorganisms.
Airfree
®
must be continuously on in the same room, 24 hours a day.
Airfree
®
is to be used in rooms with minimum air volume of 10 m
³
.
Airfree
®
can be installed in rooms equipped with air conditioning and heating systems.
However it is recommended not to place it nearby to avoid potential interference in Airfree
®
air flow.
Airfree
®
can be placed in corridors but the air sterilisation effects will barely have any effect
in connecting rooms.
Airfree
®
shall not be placed near doors or under windows to avoid sterilised air to exit the
room.
Check if the area is compatible with the unit capacity to achieve best unit performance. Using
Airfree in rooms larger than its capacity will greatly reduce its purifying capacity.
To change top light colours press the sensor on the top of Airfree’s logo. Each touch will switch
to the next colour. For the random mode please switch to pink and let it be. Maintaining finger
pressed on the sensor will increase or diminish brighteness.
