4
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
MOUNTING BRACKET INSTALLATION
CEILING
WIRING
MOUNTING
BRACKET
FLAT
WASHER
GREEN
GROUND
WIRE
CEILING FAN
APPROVED
OUTLET BOX
APPROVED
OUTLET
BOX
HARDWARE
NOTE:
On sloped ceilings, align the canopy
opening towards the top or room peak.
Step 5.
Attach the bracket to the ceiling fixture outlet
box with the mounting hardware included with the outlet
box.
Tighten the screws firmly by hand only, being careful not
to bend the bracket by over tightening.
Step 6.
To hang the fan body in the mounting
bracket, hold the fan body firmly and insert
the ball into the bracket opening. Check that
no wires were pinched. Rotate the fan body
until the slot in the nylon ball fits into the
pin opposite the bracket opening.
HANGING THE FAN
CAPPED BLUE D1-OPTION WIRE ON 3-SPEED ONLY
FOR INDEPENDENT W-80 LIGHT CONTROL
PIN
SLOT
BALL
D1
OPTION
WIRE
NOTE:
Fan weight is 19 lbs.
PUNCH HOLES IN RUBBER GASKET
Step 4.
Run the wires from the ceiling outletbox through
the center hole of the rubber canopy gasket.
Center the rubber canopy gasket over the ceiling fixture
outlet box. Using the “L” shaped screwdriver provided,
punch a hole through the rubber gasket through the screw
hole of the ceiling fixture outlet box. Repeat for other
screw hole.
RUBBER
CANOPY
GASKET
CEILING
WIRING
CEILING FAN
APPROVED
OUTLET BOX
RUBBER
CANOPY
GASKET
“L” SHAPED
SCREWDRIVER
(PROVIDED)
Summary of Contents for LA HABRA
Page 1: ...LA HABRA OWNER S MANUAL...
