September 11, 2014
[
AIR-FLO MANUFACTURING CO., INC.
]
PSV PICK-UP SPREADER OPERATOR AND PARTS MANUAL
|
9
3. “BLAST” Position: While this switch is in this position and the engine is
running, the spreader feed chain and the spinner disk will dispense the ice
control material at a higher rate. (note: in order to use this option, the switch
must be held in this position. It cannot be toggled like the “ON” or “OFF”
options)
b.)
The ignition switch is a three position switch with the following functions:
1.
“OFF” Position: While in this position, 12 VDC power is shut off to the
spreader. (Note: to turn off the spreader, toggle switch to “OFF”
position.)
2.
“ON” Position: While in this position, 12 VDC power is turned on to the
spreader.
3.
“START” Position: While in this position, the spreader’s engine starter is
activated.
c.)
The throttle switch is a two position switch with the following functions:
1.
“CHOKE/FAST” Position: While in this position, the engine speed will
increase
2.
“IDLE” Position: While in this position, the engine speed will decrease
2.)
Starting the Engine:
a.)
Verify that the clutch switch and ignition switch on the cab control panel are in the
“OFF” position.
b.)
Turn the spreader ignition switch to the “ON” position
c.)
Move the throttle switch on the cab control panel to the “IDLE” position, and hold
for approximately two seconds.
d.)
Turn the ignition switch to the “START” position
e.)
While the engine is cranking, move the throttle switch to the “CHOKE/FAST”
position
f.)
Release the throttle switch when the engine starts to fire
g.)
Release the ignition switch when the engine starts
h.)
After the engine starts, move the throttle switch to the “IDLE” position to release
the choke (hold switch for 1/2 - 1 second)
3.)
Stopping the Engine:
a.)
To stop the engine, push the toggle switch to the “OFF” position
