OPERATING INSTRUCTIONS
Make sure the machine is unplugged from the mains.
Unscrew the safety cap
(2)
by turning it counterclockwise.
Using the measuring jug and funnel
(20),
fill the
machine with up to 1200ml of water.
This should be
sufficient to steam clean for approximately one hour.
Once full, replace the safety cap by turning clockwise
and fasten tightly.
Attach the accessory or floor cleaning tool you require
to the machine.
Now plug the machine into the mains and switch on.
Two lights should illuminate. The
red light
(5)
is a
power indicator. The orange light
(6)
indicates that
the machine is
building up steam pressure. When the
machine is first switched on this light will
illuminate and
the machine can take up to 8 minutes to reach the
correct pressure level
depending on the amount of
water in the tank.
Once the orange light has gone out, the machine is
ready to use. The orange light may
come back on
when the machine is in use. If this happens, release the safety trigger
and
allow the steam pressure to build up once again. This should take no
longer than 40
seconds. If the safety trigger is pressed when the orange
light is on hot water may come
out of the machine.
REFILLING THE WATER TANK
Switch the machine off using the on/off button(4)
Disconnect the power cable from the mains.
Wait 5 minutes before squeezing the safety trigger to make sure that the machine is no
longer under pressure. Then, unscrew the safety cap. DO NOT unscrew the safety cap
until the steam has stopped.
Fill the water tank as necessary using the funnel provided.
DO NOT exceed 1200ml of water before replacing the safety cap by turning clockwise.
Fasten cap tightly.
You are now ready to switch the machine on and resume steam cleaning.
If you live in a hard water area, it is best to use distilled water (this
prevents internal lime
scale that may damage the steam system)
