PAGE: 6 / 9
Remove the 4 hanger bracket screws
and washers from the hanger bracket.
Attach the canopy to the hanger
bracket, then secure it with four
screws and washers.
Screw
Hanger Bracket
Washer
Canopy
Fig. 12
Fig.11
Hanger
Bracket
Hanger
Ball
Receiver
1.
4. 5.
6.
2.
3.
Antenna:
DO NOT CUT
OR SPLICE
Connect wires:
1) The white (neutral) wire from motor to the white (neutral)
"To Motor N" wire from Receiver with a wire nut.
2) The black (hot) wire from motor to the black (hot) "To
Motor L" wire from Receiver with a wire nut.
3) The blue wire from motor to the blue "For Light" wire
from Receiver with a wire nut.
4) The white (neutral) wire from Outlet Box to the red "AC
in N" wire from Receiver with a wire nut.
5) The black (hot) wire from Outlet Box to the red "AC in
L" wire from Receiver with a wire nut.
6) The ground wire from Outlet Box to the green ground
wire from the Hanger Ball and the green ground wire
from the Hanger Bracket with a wire nut.
Make sure all of wire nuts are connected firmly.
*** Put all wire nuts and wires carefully up into the Outlet Box,
EXCEPT antenna, which should remain outside Outlet Box.
Fig.10
Move ground wires (a), outlet box wires (b), and
motor wires (c) away from the center of the hanger
bracket. Then slide receiver through hanger
bracket as shown, Antenna end first, until it is
centered. Finally, cut motor wires (c) to length
needed for connections.
Antenna
Receiver
Hanger Bracket
Code example:
1-ON 2-OFF 3-ON 4-OFF
on both DIP Switches.
a.
b.
c.
Fig.9
Antenna
DIP Switch
Transmitter
Receiver
Fig.9a
There is a code switch in the transmitter
and receiver. This "DIP Switch" is a 4 key
unit (Fig.9). All keys were set at "ON"
position in the beginning. Set the keys to
a different code. Make sure the same
numbered keys are switched "ON" for
both DIP Switches (Fig.9a). Take note
that the "ON" position may have different
orientation for each.
F A N C O
140819
Hang the safety cable
into the safety cable hook.
Fig.13
Safety Cable Hook
Safety
Cable
