3
Risk of electric shock
: The electrical installation must be performed by a qualified electrician and
must be in accordance with national and local regulations.
Risk of injury
: In case you need to drill holes for mounting the fan, make sure that the drills have
sufficient distance to in-ceiling wiring.
1.
Pass the supply wires through
the hole in the mounting bracket.
Secure the mounting bracket to a
ceiling joist or other structural
ceiling element with two screws and
flat washers. Ensure that the
support for the mounting bracket is
capable of safely holding the
moving weight of the fan.
2.
Remove the lock pin and take
off the hanger pin.
Slide canopy
and downrod stand cover onto
downrod as shown. Then thread
wires from fan assembly through
downrod.
3.
Insert the downrod into the
collar. Slide hanger pin through
holes of collar and downrod.
Insert and tighten the two collar
screws. Slide lock pin into
hanger pin until it locks into
position.
4.
Hang the fan assembly with the
ball joint onto the mounting bracket.
Make sure the guide pin of the
bracket is fitted into the
corresponding slot of the ball joint.
You should feel the guide pin
setting into the slot of the ball joint.
Note: For slope ceiling installation,
make sure the guide pin of the
hanger bracket is toward the floor.
5.
Terminal block wire connections:
First, loosen the screws on the
terminal block, then make sure that
all exposed wires are inside the
terminal block and screws are
securely tightened again. Then,
make wire connections of supply
wires with corresponding wires
from fan using the other side of the
terminal block.
Note
–
wiring from fan:
brown (L)
blue (N)
green/yellow (ground)
6.
Tuck all wires into the
canopy. Push the canopy
upwards, lining up the
keyholes on the bottom with
the screws on the hanger
bracket. Twist the canopy
to lock it in place, then tighten
the screws to secure it.
7.
Attach nipple to the coupling,
and secure it with a hex nut. Install
suitable bulbs (E14 socket, 60W
max.; not included).
8.
Attach the glass shade
and metal pad through the
nipple, secure them
together with a hex nut and
finial.
