UPDATE THE CLOCK AND DAY:
Go to Prog Mode 'steady green LED'.
Press the 'MODE' button to enter the setting menu.
'(To do a new time update, press the 'MODE' button for 3s a 2nd time)'.
The day in memory is displayed:
Modify with the + and -‐ buttons Confirm by pressing the MODE button
The time in memory is displayed:
Modify with the + and -‐ buttons Confirm by pressing the MODE button
The minute in memory is displayed:
Modify with the + and -‐ buttons Confirm by pressing the MODE button
During a power outage exceeding 30 minutes, the thermostat loses the time If it is in programming
mode and there is a P1, P2 or P3 programme applied to the day of the week, the thermostat reminds
the user that they need to reset the time by displaying a flashing 'Hr'.
HARMONISING DISPLAYS (THERMOSTAT/THERMOMETER):
Exceptionally, it may be that, in some conditions, there was a difference in the display of the device
and that of your thermometer. In this case, it is possible to harmonise both displays by entering the
temperature read on the thermometer.
This setting can only be realised if your device is set between 17-‐23°C. All the doors and windows
must be closed.
Wait for the temperature to stabilise in the room (at least 6 hours) and prevent (as far as possible)
people from entering and leaving the room.
The control thermometer must be placed in the middle of the room at 1.2 m from the floor. Do not
place it on any item of furniture.
Go into 'Comfort' mode with the MODE button, e.g. 19
Press the MODE button for 6 seconds, two possibilities:
Either the display flashes 19 and harmonisation is then possible.
•
Modify with the + and -‐ buttons
•
Confirm with the MODE button
54.
