Stick Function Test On Ground
After power-on test and everything goes fine then install propellers to do stick function test on ground.
1
Put X450 level in ground, beside it is RC. At the same time do RC movements.
2
First throttle down to lowest then start RC.
3
Power on X450.
4
Hold back the lift of X450(Be careful not to be hurt) and apply Throttle to 20% slowly and keep it for a while.
5
Observe whether all propellers spin freely to the right direction.
a) If not in the right direction, lower the throttle to minimum and power off X450.Reinstall propellers to test again until it works in the right way.
b) If not in a smooth way, throttle down to lowest and power off X450.Check electronic circuit and motors to retest until it goes well.
6
If every part works fine, and keep the throttle at 20% and try to push stick slightly in Pitch, Roll and Yaw(stick value 30%).Feel whether aircraft
attempts to move to the corresponding direction.
7
If showing wrong direction to any of Pitch, Roll and Yaw, adjust signal cable connection order of receiver to test again until it becomes normal.
8
Throttle back to lowest and power off X450.
Front
Ground
Pay attention to rotating blades from getting hurt
.
CAUTION
M1
M4
M2
M3
Mode
1
Mode1 For Example
18
www
.
xaircraft.com
