Aircraft XAircraft X450 Pro, Instruction Manual

Page: 20 / 22

地面摇杆操作测试后，进行传感器工作状态测试。
1 拔出飞行模式选择通道 的连接线。
2 将遥控器油门收到最小后打开遥控器开关。
3 X450 Pro 接通电源。
4 半蹲姿势，左手抓紧 X450 Pro 的底部，举到前上方，高度高于头顶。
5 右手轻推油门至 20% 的杆量。
6 尝试使用左手使飞行器前、后、左、右倾斜，感觉飞行器是否阻止您使飞行器倾斜。
7 如果飞行器没有阻止您使它倾斜，则将油门收到最小，断开 X450 Pro 电源，重新检查电路
安装（如 AHRS 的安装方向是否正确，连接线是否接好）后再次测试。
8 如果飞行器的反应正确，将油门推最小，断开 X450 Pro 的电源，就可以进行首次试飞了。
（默认为 Input5 ）
姿态传感器工作状态测试 AHRS Function Test
After X450 Pro stick function test on ground now it goes sensor test.
1 Unplug Flight Mode channel signal cable (default Input 5).
2 Throttle down to lowest then turn on the transmitter.
3 Power on X450 Pro.
4 Squat and grasp the bottom side of X450 Pro to lift it higher than your head.
5 Apply throttle slowly to 20%.
6 Try to bank the aircraft forwards, backwards, left side and right side and feel it
whether aircraft has stopped your moving.
7 If no resistance, throttle down to lowest and power off X450 Pro.Check if
electronic parts installs properly.(Like AHRS installation orientation or good
connection).Then test again.
8 If aircraft reacts perfect, throttle down to lowest and power off X450 Pro.Now
you can start your first fly and enjoy it.
测试时请注意安全， 避免被螺旋桨击中。
Pay attention to rotating blades from getting hurt .
18