地面摇杆操作测试
Stick Function Test On Ground
首次通电测试完成并确认正常后，安装螺旋桨，进行地面摇杆操作测试。
1
将
X650 Value
X650 Value
边。
2
将油门收到最小后打开遥控器。
3 X650 Value
接通电源。
4
左手按住
X650 Value
的机身抵抗飞行器的升力（注意安全，避免螺旋桨伤到自己），右手轻推油门到
20%
的油
门量，并保持。
5
观察四个螺旋桨的启动是否顺畅，旋转方向是否正确。
a
) 如果旋转方向不正确，则将油门收到最小，断开
X650 Value
电源，重新安装螺旋桨后再次进行测试，直到
螺旋桨的旋转方向都正确。
b
) 如果旋转不畅，则将油门收到最小，断开
X650 Value
电源，检查电路和电机后，重新测试直至正常。
6
如果正常，保持
20
%的油门量，尝试分别轻推俯仰、横滚、旋转（杆量为
30%
），左手感觉飞行器是否有朝相
应方向运动的趋势。
7
如果俯仰、横滚、旋转的方向不正确，则调整接收机信号线的连接顺序，再次进行测试直至正常。
8
将油门收到最小，断开
X650 Value
的电源。
放到水平地面上，遥控器放到
旁
测试时请注意安全， 避免被螺旋桨击中。
Pay attention to rotating blades from
getting hurt
.
After power-on test and everything goes fine then install propellers to do stick function test
on ground.
1 Put X650 Value level in ground, beside it is transmitter.
2 First throttle down to lowest then turn on the transmitter.
3 Power on X650 Value.
4 Hold back the lift of X650 Value(Be careful not to be hurt) and apply Throttle to 20%
slowly and keep it for a while.
5 Observe whether all propellers spin freely to the right direction.
a) If not in the right direction, lower the throttle to minimum and power off X650
Value.Reinstall propellers to test again until it works in the right way.
b) If not in a smooth way, throttle down to lowest and power off X650 Value.Check
electronic circuit and motors to retest until it goes well.
6 If every part works fine, and keep the throttle at 20% and try to push stick slightly in
Pitch, Roll and Yaw(stick value 30%).Feel whether aircraft attempts to move to the
corresponding direction.
7 If showing wrong direction to any of Pitch, Roll and Yaw, adjust signal cable connection
order of receiver to test again until it becomes normal.
8 Throttle back to lowest and power off X650 Value.
16
www
.
xaircraft.com
M1
M3
M2
M4
