4
SETTING UP THE SMART REMOTE PRO
Installing Batteries
Remove the battery cover on the back of the Smart Remote Pro. Insert two AAA (VM-4, R03)
batteries. Should the remote not operate, Slide down the keypad cover and use a pen or a point to
press hold and release the ‘RESET” button. This will reboot the remote without losing settings.
(Also Refer to the Operating notes and Troubleshooting Section at the end of this guide)
To make battery compartment tamperproof, fit security screw in battery cover plate.
TO MAKE ANY SET UP CHANGES THE SET UP FUNCTION MUST BE UNLOCKED
How to set the Minimum and Maximum Temperature Settings
The Smart Remote Pro is supplied with default temperature operating settings of 2 °-30° for
Cooling Mode and 17° -23° for Heating Mode. It is possible to adjust these as required. If
required the temperature ranges can be changed to any value between 17° – 30° for each Mode.
(Eg. 23°-29° for cooling and 18°-21° for Heating). The minimum and maximum values for a range
must be at least one degree apart.
How to Set Minimum Temperature for Cool Mode.
If necessary unlock the Set Up Function.
1
. Simultaneously press both the “SELECT” button & the “TEMP –“ (Down) ” button for 3
seconds, screen will flash “Lo”, then release.
2
. Press and release “iCOOL” button. The “COOL” symbol will flash. Then enter chosen
minimum temperature for Cool mode by using the Temp “+” & “-“ buttons.
3
. Press and release the OK/ENTER button to lock it in.
How to Set Maximum Temperature for Cool Mode
.
If necessary unlock the Set Up Function.
1
. Simultaneously press both the “SELECT” button (S) & the “TEMP +” (Up)” button (next to
Blue Power Button). After 3 seconds, the screen will flash “Hi”, then release.
2
. Press and release “iCOOL” Button. The “COOL” symbol will flash. Then enter chosen
maximum temperature for Cool mode by using the Temp “+” & “-“ buttons
3
. Press and release the “OK/ENTER” button to lock it in.
How To Unlock the Set Up Function Keypad
Press the Power Button to wake up the remote, then slide down the keypad cover on the front of
the remote to expose the keypad.
Unlock the Set Up Function by pressing and holding the “Time+” key for 4 seconds and then
release. The Set Up Function will automatically relock after 3 minutes of no activity.