17
6. RADIOSTACK PANEL - USER’S MANUAL SOLO GA
Change between
ADF & ANT mode
In Use Frequency
Stand By Frequency
FRQ Mode
Enables BFO
modulation
Enables
FRQ mode
and freqcy
transfer
Power
switch
Hundreds and
thousands
selector
Units
selector
6.5. AUTOMATIC DIRECTION FINDER (ADF)
This is 100% functional; the ADF and BFO buttons are working but per-
form no actions.
(FS does not allow the user to move the needle to 90º
as would be usual in ANT mode).
Note: NO dash appears when frequency is changed in this device.
FREQUENCY MODE (FRQ)
In its main mode, it shows two frequencies: Used and Standby.
FLIGHT TIME MODE (FLT)
An internal chrono is started when the device is activated, and it counts
both Hours and Minutes. It always works (in any mode) while the device
is On.
FLT Mode indication (HH:MM)
ET Mode indication (MM:SS)
(The picture shows 3 minutes in FLT mode)
FLT and ET modes switch
Starts and reset the chrono, and
enable the countdown mode
CHRONO MODE - Elapsed Time (ET)
The ET mode allows a chrono with Minutes and Seconds (until 59:59).
The chrono begins to count when you press SET/RST push button (also
when other mode is selected) and returns to start every time SET/RST is
pressed. Can not be stopped, always is reset to 0 and begins to count
automatically.
COUNTDOWN MODE (ET blinking)
A countdown of a maximum of 59 minutes, 59 seconds i allowed. To
enter countdown mode, the SET/RST pushbutton must be pressed and
mintained (with the mouse) for 2 seconds or longer, or until ET starts to
blink.
Subsequently, you should select the initial time with the rotatory knobs,
the big one to select the minutes and the small for the seconds, and
press the SET/RST pushbutton to start the countdown.
When the time reaches 0 the mode reverts to normal ET Mode and
begins to count up, but to advise you of the time blinks for 15 seconds.
ET Countdown (MM:SS) - ET Blinking
Pressed > 2 seconds enables the
countdown mode (ET blinking)
Minutes
selector
Seconds
selector
