AIR-I40279A
REV 10/29/18
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are
not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water.
WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
700-510 Airaid Oiled Media
701-510 Airaid SynthaMax Dry Media - Red
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common
non-petroleum all-purpose household cleaner
and water. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner to outside of
air filter and allow to soak. Then flush filter clean
from the inside out with a garden hose and repeat
steps if necessary. Do not apply high pressure
water or air to clean filter. Allow filter to air dry
and reinstall.
Airaid. 1455 Citrus St., P.O. Box 1329, Riverside, CA. 92502 1-800-498-6951 [email protected] www.airaid.com
For your Oiled media filter we offer the
Airaid Tune Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
16.
Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!
Continued...
7. Install the provided bumper into the AIRAID
®
housing as shown.
8. Install the provided weather strip onto the AIRAID
®
housing as shown.
NOTE: Some trimming of the edge trim will be
necessary.
9. Install the AIRAID
®
housing into the vehicle so the
mounting stud inserts into the mounting grommet and
the fresh air intake opening sits around the fresh air
duct.
NOTE: Be sure not to pinch the wiring harness
between the fresh air duct and AIRAID
®
housing.
10. Install the provided coupler (08695) onto the turbo
inlet and secure with the provided hose clamp.
11. Remove the mass air sensor from the factory air
filter housing and install it into the AIRAID
®
intake tube
using the provided hardware and spacers. Install the
AIRAID
®
decal onto the intake tube.
12. Install the AIRAID
®
intake tube into the AIRAID
®
housing and into the coupler at the turbo inlet. Adjust
the tube for best fit and then secure with the provided
hardware and hose clamp.
13. Install the air filter onto the intake tube and secure
with the provided hose clamp.
14. Reconnect the mass air sensor electrical connection.
