Air-Vac PHS1500, User Manual

Page: 7 / 24

PHS1500/4000 User’s Guide
1029.00.902 5
Machine Operation
•
All heated areas can be programmed to reach high temperatures. Use caution near heated sur-
faces including the heater surface, carrier components and boards being held in the carrier.
•
Observe the legal and specific national regulations concerning accident prevention and protection
of the environment.
•
Observe the general safety regulations concerning working with solder and flux. Fume extraction
should considered if required.
Caution: Operation of this module involves hot surfaces. All normal safety practices must be observed.
Personnel
•
Safety glasses should be worn at all times. Wear protective gloves when working with solder.
Solder contains tin and lead, which are hazardous materials.
•
Place any waste solder or dross in a heat resistant dross container.
•
Always wash hands after working with solder.
•
Use caution if wearing loose clothing while operating this machine as loose clothing can contact
hot surfaces or become caught on something. Always secure loose clothing before operating
this equipment.
•
Never eat, drink, or smoke while working on or near the machine.
•
Only trained operators and technicians should work on this equipment.
•
Molten solder and hot surfaces will cause severe burns. Use extreme caution when operating
this equipment. Heat resistant gloves are recommended particularly when placing and removing
boards from the carrier.
•
Report any problem to supervisor.
Equipment
•
Flux vapors result from soldering or desoldering. Fresh air must be provided. A venting system
or fume extraction system is recommended.
•
Keep all covers on. Do not open machine covers unless you are a qualified technician perform-
ing troubleshooting or maintenance.
•
In the event of an emergency, turn off the red power switch located on the front of the machine.
Locate this switch before operating this machine.
•
Shut off electrical power and unplug machine when servicing any area of the machine.
•
Refer to material safety data sheet of solder, flux, or any other product used in conjunction with
the machine. Follow all warning labels and instructions.
Maintenance
•
Only qualified personnel are allowed to work on the machine.
•
As a basic rule, disconnect the main power before servicing the machine or when the machine is
taken off line.
•
Only use the tools for their defined purpose.