3. Mount with mounting holes
Slide one hanger bar into the channel on the housing and adjust as needed to fit
between framing. Hold housing in place so that the housing contacts the bottom of
the joist, Screw housing to joist through the hole A and hole B. Screw the hanger bar
onto the other side of joist through its hole.
Screw hanger bar to housing with screw A.
ASSEMBLY INSTRUCTIONS
4. Mount to I-joist
Slide hanger bar into the channel on the housing and adjust as needed to fit I-joist.
Hold housing in place so that the housing contacts the bottom of joist. Screw
housing to joist through the hole A and hole B. Screw the hanger bar onto the joist
through its hole.
Screw hanger bar to housing with screw A.
6. INSTALL ROUND DUCTWORK
5. Wall installation
5a. When the product is installed on the wall, the adaptor shall be faced upward.
5b. Slide hanger bar into the channel on the housing. Hold housing in place so that
the housing contacts the bottom of stud. Screw housing to stud through the hole
A and hole B on the same side. Screw the hanger bar onto the stud through its
hole.
Screw hanger bar to housing with screw A.
The minimum installation distance between studs is 13 3/8 in. (340mm)
Connect the round ductwork (not included) to the damper/duct connector, and run
the ductwork to a roof or wall cap (not included).
Using tape (not included), secure all the ductwork connections so that they are air
tight.The ducting from this fan to the outside of building has a strong effect on the air
flow, noise and energy use of the fan. Use the shortest, straightest duct routing
possible for best performance, and avoid installing the fan with smaller ducts than
recommended. Insulation around the ducts can reduce energy loss and inhibit mold
growth. Fans installed with existing ducts may not achieve their rated air flow.
Screw B
Screw A
Screw B
Screw B
Hanger
bar
Stud
Screw A
Screw B
Screw B
13 3/8 in. (340mm)
Screw A
2. Mount with mounting holes
Hold housing in place so that the housing contacts the bottom of the joist,
Screw housing to joist through the hole A and hole B.
Screw B
Screw B
3
