MN-1159
1. There are three choices for mounting:
• Hex cap bolts (M) with flat washers (L) and nylon
lock nuts (K).
• U-bolt (J) with washers (L) and nylon lock
nuts (K). See Figure 3 for U-bolt installation.
• Self-tapping screws (N).
2. EZ Mount can be mounted in any orientation except
with the logo upside down or the logo facing the
ground (Fig. 1). There are mounting holes in the side of
the bracket and in the top. Use the included template
(Fig. 4) for mounting with self-tapping screws or hex
cap bolts. Use a 1/4" drill bit to make pilot holes if
using self-tapping screws.
BEFORE DRILLING, ENSURE THAT THE BACK SIDE
IS CLEAR OF VEHICLE COMPONENTS, INCLUDING
BRAKE LINES, FUEL LINES, AND WIRING.
3. Do not remove components from the EZ Mount assembly.
REMOTE FILTER INSTALLATION
1. Screw 1/4" FNPT x 1/4" barbed tube fitting onto inlet air filter, hand-tighten. No
thread sealant needed.
2. Attach 1/4" air line, provided in the filter pack, to barbed tube fitting on remote inlet
air filter.
3. Locate appropriate area where remote inlet filter is to be installed. Keep in mind that
location should be dry and away from heat source, and that the air inlet slots on the
inlet air filter are free from blockage.
4. Secure remote filter appropriately using proper fastening methods or drill a 3/8"
mounting hole and push remote filter bracket pin into the mounting hole.
5. Route air line to inlet port of the compressor. Measure and cut squarely to
appropriate length (Fig. 6). Make sure when routing you keep away from sharp edges
and you allow for proper bend radius (see Cutting the Air Lines) to avoid kinking.
6. Attach cut end of 1/4" air line to barbed tube fitting of air inlet port on compressor.
Installing WirelessAir EZ Mount
CAUTION
U-bolt installation
fig. 3
