MN-203
6
OPERATION INSTRUCTION
1. Always follow inflation instructions provided with your air spring kit. Maintain at least
the minimum recommended pressure and never exceed the maximum recommended
pressure.
2. To add pressure, push the top button to start the compressor and as soon as it reaches
the desired ride height release the button again to stop the compressor.
RUN THE COMPRESSOR IN 4 MINUTE INTERVALS TO ALLOW COOLING OF THE
COMPRESSOR.
3. To reduce pressure, push the deflate valve under the on/off switch on the panel.
CHECK AIR LINE
1. Turn the compressor on and inflate the system to the maximum for your Air Lift or air
shock kit.
2. Check all air line connections for air leaks with a soapy solution. Deflate to minimum or
desired pressure.
TROUBLESHOOTING
1. Compressor does not run - check all wiring and make sure you have a good ground.
Check in-line fuse.
2. Compressor runs but air shocks to not pressurize or lose pressure - Test all air line
connections with a soapy solution to determine where the air leak is. Replace air line if
it is leaking. Also check valve core under deflation button. Tighten if leaking.
3. If problems persist, call Air Lift Customer Service at 800-248-0892.
CAUTION
LoadController II
