9
MN-833
LoadLifter 5000 Ultimate
SECURING THE EMERGENCY BRAKE CABLE
1 . Attach the supplied clamp around the emergency brake cable and secure it to the
lower bracket using the previously removed stock bolt . Tighten securely (Fig . 14) .
2 . Cut the existing emergency brake cable bracket close to the cable (Fig . 14) .
Install supplied
clamp around the
emergency brake
cable, securing to
the lower bracket.
fig. 14
Cut off existing
brake bracket
close to the
brake cable.
fig. E.3
TIPS FOR INSTALLING AIR LINES
When cutting air lines, use a sharp knife or a hose
cutter and make clean, square cuts (Fig . E .3) . Do not
use scissors or wire cutters because these tools may
deform the air line, causing it to leak around fittings .
Do not cut the lines at an angle .
Do not bend the 1/4” hose at a radius of less than 1” or
bend the 3/8” hose at a radius of less than 1 1/2” . Do
not put side load pressure on fitting . The hose should be
straight beyond the fitting for 1” before bending .
Inspect hose for scratches that run lengthwise on hose
prior to installation . Contact Air Lift customer service at
(800) 248-0892 if the air line is damaged .
To watch a video demonstrating proper air
line cutting, go to
air-lift .co/cuttingairline .
fig. 13
TIPS FOR INSTALLING AIR LINES
When cutting air lines, use a sharp knife or a hose
cutter and make clean, square cuts (Fig . 13) . Do not
use scissors or wire cutters because these tools may
deform the air line, causing it to leak around fittings .
Do not cut the lines at an angle .
Do not bend the 1/4” hose at a radius of less than 1” or
bend the 3/8” hose at a radius of less than 1 1/2” . Do
not put side load pressure on fitting . The hose should be
straight beyond the fitting for 1” before bending .
Inspect hose for scratches that run lengthwise on hose
prior to installation . Contact Air Lift customer service at
(800) 248-0892 if the air line is damaged .
To watch a video demonstrating proper air
line cutting, go to
air-lift .co/cuttingairline .
