LoadLifter 5000 Series
MN-1047
9
4. Attach the axle strap (F) to both lower bracket carriage bolts using two flat washers
(J) and two nylon lock nuts (L). Torque evenly to 16 lb.-ft. (22Nm) (Fig. 9).
INSTALLING THE EMERGENCY BRAKE LINE BRACKET
AND CLIP (DRIVER’S SIDE ONLY)
1. Attach the brake line bracket (Q) to the lower bracket using the previously installed
5/16” bolt (O) with one flat washer (J) and a nylon lock nut (M) (Fig. 1 & 10).
2. Attach the brake line clip (N) onto the emergency brake line bracket (Fig. 1 & 10).
3. Attach the clip assembly to the brake line bracket using a 5/16” bolt (O), two flat
washers (J), and a nylon lock nut (M) (Fig. 1 & 10).
4. Align the brake line bracket and clip assembly so that the two do not bind to the
cable. Tighten all mounting hardware in this assembly securely.
Be sure the cable does not rub against the air spring when it is fully inf lated. If it does,
adjust the assembly accordingly.
fig. 10
Brake line clip (N)
Brake line
Brake line
bracket (Q)
5/16” Bolt (O)
5/16” Flat washer (J)
Nylon lock nut (M)
fig. 9
Nylon lock nut (L)
Flat washer (J)
Axle strap (F)
NOTE
